148
Adjusting the color tones (White
balance)
The color tone of the subject changes depending on the characteristics of
the light source. The table below shows how the color tone changes based
on various light sources, compared with a subject that appears white under
the sunlight.
Use this feature when the color tone of the image did not come out as you
expected, or when you want to change the color tone on purpose for
photographic expression.
Notes
• When the exposure mode is set to AUTO, AUTO+, or Scene Selection, [White
Balance] is fixed to [Auto WB] and you cannot select other modes.
• If the only light source available is a mercury lamp or a sodium lamp, the camera
will not be able to acquire the accurate white balance because of the characteristics
of the light source. Use the flash in such cases.
Weather/
lighting
Daylight Cloudy Fluorescent Incandescent
Characteristics
of light
White Bluish Green-tinged Reddish
WB button t Select the desired
setting
• When you select a setting other than
[C.Temp./Filter], press B on the multi-
selector so that the fine adjustment
screen appears and you can adjust the
color tone with v/V/b/B, as necessary.
WB button
To Next Page
Loading...
Need help?
General
