Help Guide
Multi Channel AV Receiver
STR-AZ1000ES
Calibrating speaker positioning (SpeakerRelocation / PhantomSurroundBack)
This function calibrates the speaker positioning (angle of each speaker’s configuration from the measurement position) based on the
measurement results of D.C.A.C. IX (Digital Cinema Auto Calibration) function to bring the sound closer to the surround-sound effect
obtained with ideal speaker positioning. Thus, for example, this function can allow you to enjoy a surround-sound effect acoustically
equivalent to that of a 7.1.2-channel speaker system, using only a 5.1.2-channel speaker system.
Note
This function does not work in the following cases:
[Direct] is being used and an analog input is selected.
[In-Ceiling Speaker Mode] is set to [Front & Center] or [Front].
[DSD Native] is set to [On] and DSD signals are being played back.
Select [Setup] - [Audio Settings] from the home menu.
1
Select [SpeakerRelocation / PhantomSurroundBack].
2
Select the setting you want.
Type A: This function adjusts each speaker’s distance and angle to simulate the sound of an ideally placed surround system.
When surround speakers are available, the surround back speakers sound as if they have been placed on the back wall.
When height speakers such as front high speakers or top middle speakers are available, the height speakers sound as if they
have been placed on each side directly aligned with the front speakers.
Type B: This function adjusts each speaker’s distance and angle to simulate the sound of an ideally placed surround system.
When surround speakers are available, the 4 surround speakers sound as if they have been placed at the identical angle.
When height speakers such as front high speakers or top middle speakers are available, the height speakers sound as if they
have been placed on each side directly aligned with the front speakers.
Off: Speaker positioning is not relocated.
3
To Next Page
