Help Guide
Multi Channel AV Receiver
STR-AZ1000ES
No image appears on the TV screen.
Try pressing the input button on the remote control or turning INPUT SELECTOR on the unit to select the input to which you want to
watch.
If the TV is connected to the HDMI OUT B/ZONE 2 jack, reconnect the TV to the HDMI OUT A (TV) jack.
If the HDMI video signal output is set to [HDMI OFF] or [HDMI B], select [HDMI A] or [HDMI A+B] by pressing HDMI OUT on the unit or
remote control.
Set your TV to the appropriate input mode.
Make sure that cables are correctly and securely connected to devices.
Disconnect the HDMI cable from the unit and TV and then reconnect the cable.
Change the [HDMI Signal Format] setting of the selected input in the [HDMI Settings] menu.
Some playback devices need to be set up. Refer to the operating instructions supplied with each device.
Be sure to use a Premium High Speed HDMI Cable with Ethernet, which supports bandwidths up to 18 Gbps. For video signals that
require a high bandwidth such as 4K/120p, 8K, etc., be sure to use an Ultra High Speed HDMI Cable that supports bandwidths up to
48 Gbps.
If you want to play HDCP 2.2 or HDCP 2.3 content, connect the unit to an HDMI input jack of a TV that is compatible with HDCP 2.2 or
HDCP 2.3.
Digital video signals input to the HDMI IN jacks of this unit are output only from the HDMI OUT A (TV) or HDMI OUT B/ZONE 2 jack.
Analog video signals input to the VIDEO IN jacks are output only from the MONITOR OUT jack. For details, see “About input/output of
video signals.”
Related Topic
Notes on connecting cables
About HDMI connections
5-037-020-11(1) Copyright 2022 Sony Corporation
To Next Page
