Sony STR-DA4600ES - Page 125

125
GB
Adjusting Settings
5 Press V/v/B/b and to select a
character one by one to enter the IP
address.
6 Select “Finish,” then press .
7 Press b to display the next screen.
8 Repeat the process in steps 4 to 7
again to enter the Subnet Mask,
Gateway address, DNS1 address, and
DNS2 address.
9 Select “Test Connection,” then press
.
“Success! The receiver is now connected to
network.” appears on the TV screen.
10Press to select “Finish.”
To set the Proxy server
manually
1
Select “Network Setup” then press .
2 Select “Proxy Setup,” then press .
3 Select “Enable,” then press .
4 Press .
The soft keyboard appears on the TV
screen.
5 Press V/v/B/b and to select a
character one by one to enter the proxy
server address.
6 Select “Finish,” then press .
7 Press b to select the Port number box,
then press .
The soft keyboard appears on the TV
screen.
8 Press V/v/B/b and to select a
character one by one to enter the port
number.
9 Select “Finish,” then press .
10Press b.
11Select “Finish,” then press .
Let you turn the function which controls the
receiver from external controllers on the home
network on or off.
x OFF
x ON
Note
If you set “Controllers,” set “External Control” to
“ON.”
Lets you set availability of operations allowed
for the receiver for network controllers on the
home network that have attempted to access
the receiver in the past.
1 Select “Controllers,” then press
.
The setting screen used for Controllers
appears on the TV screen.
2 Select the controller you want
to allow to operate the receiver
from the list, then press to
check the box.
When you check the box for “Auto
Permission,” all the controllers detected
are checked automatically.
3 Select “Finish,” then press .
To cancel the setup
Select “Cancel,” then press in step 3.
To remove the detected
controllers from the list
1
Select the controller you want to
remove from the list, then press to
check the box.
2 Select “Remove All,” then press .
External Control
Controllers
continued