Sony STR-DH700 - Page 93

Using the Sleep Timer
You can set the receiver to turn off
automatically at a specified time.
Press SLEEP repeatedly while the
power is on.
Each time you press SLEEP, the display
changes cyclically as follows:
2-00-00
-+ 1-30-00 -+ 1-00-00 -+ 0-30-00
-+OFF
When sleep timer is being used, "SLEEP"
lights up in the display.
Tip
To check the remaining time before the receiver
turns off, press SLEEP. The remaining time appears
on the display. If you press SLEEP again, the sleep
timer will be canceled.
Recording using the
receiver
You can record from an audio/video
component using the receiver. Refer
to the
operating instructions supplied with your
recording component.
You can record onto a CD-R using the
receiver. Refer
to the operating instructions
supplied with your CD recorder.
1 Press one of the input buttons
to select the playback
component.
You can also use INPUT SELECTOR on
the receiver.
2 Prepare the playback
component for playing.
For example, tune to the radio station you
want
to record (page 62).
3 Prepare the recording
component.
Insert a blank CD-R into the CD recorder
and adjust the recording level.
4 Start recording on the
recording component, then
start playback on the playback
component.
Note
Sound adjustments do not affect the signal output
from the SA-CD/CD/CD-R
OUT jacks.
93
US