Recording20
EN
Writing Start ID when AUTO-ID is turned on
Source A Start ID is written when
All • Recording begins or the recording pause is
released. (During a soundless segment,
Start ID is written at the point where
sound is emitted.)
• A soundless segment or a segment with a
very low recording level of 3 seconds or
more.
• While sound is input the sampling
frequency is changed.
• The REC button is pressed during
recording.
Writing Start ID when AUTO-ID is turned off
Source A Start ID is written when
All • Recording begins or the recording pause is
released. (Start ID is written regardless of
whether the segment contains a sound or
not.)
• The REC button is pressed during recording.
CD player Identical to the existing program (track)
(digital input) information of the CD. (In addition to the
above.)
DAT player Identical to the existing program (track)
(digital input) information of the DAT tape. (In addition
to the above.)
Notes
• When AUTO-ID is
turned off, the existing
program (track)
information of the CD
may not be written
properly as the Start ID
depending on the CD
player in use.
• The existing program
(track) information of
the MD is not written
as the Start ID.
To Next Page
Loading...
Need help?
General
