Sony TCD-D8 Operating Instructions (primary manual) - Connecting with Other Equipment for Playback; Playback with an analog audio equipment; Playback with an audio equipment with digital input

Playback
Playback
23
EN
( Playback
Connecting with Other Equipment for
Playback
You can connect the tape-corder to other analog audio equipment and audio
equipment with digital output. Refer to page 12 for “Playing Back”.
Playback with an analog audio equipment
(Analog connection)
1 Set the PHONES (AVLS)/LINE OUT switch to
LINE OUT.
2 Begin playback and adjust the volume of the
connected equipment.
Playback with an audio equipment with
digital input (Digital connection)
Connect the digital audio equipment to this tape-
corder as shown. Begin playback and adjust the
volume of the connected equipment.
Tip
The output level of the
PHONES/LINE OUT jack
and the REMOTE
DIGITAL I/O jack is
fixed. The volume cannot
be adjusted with the
VOLUME buttons of this
tape-corder.
Note
When a plug is connected
to the PHONES/LINE
OUT jack, the tape-corder
cannot change the output
mode from LINE OUT to
PHONES (AVLS) during
playback although you
can set the PHONES
(AVLS)/LINE OUT
switch to PHONES
(AVLS), vice versa.
Optical cable
(not supplied)
DAT deck,
digital
amplifier,
etc.
To REMOTE DIGITAL I/O
Audio connecting cable
(not supplied)
PHONES/LINE OUT
Stereo unit
or radio
cassette
recorder, etc.
To LINE IN