Power Sources28
EN
Connecting with Other Equipment
Connect other equipment to this tape-corder to enable flexible use of the tape-corder.
Using the optional system adaptor kit RM-
D3K
The optional RM-D3K functions as a relay unit
between an equipment with digital I/O jack and this
tape-corder.
The RM-D3K supports input/output of both optical
and coaxial cables. Connect according to the jack of
the digital audio equipment you wish to connect.
When the RM-D3K is connected
Writing and erasing Start IDs, renumbering program
numbers, and using the Music Scan function or Direct
Search function are many of the noteworthy features
of the RM-D3K.
Using the optional super bit mapping adaptor
SBM-1
The optional SBM-1 enables recording of higher
quality when connected to this tape-corder.
Using the optional wired remote control RMT-D7
The optional RMT-D7 can be connected to the SBM-1
to enable remote control. However, when operating
the SBM-1 with the batteries, the RMT-D7 is not
operational if the power of the SBM-1 is turned off.
When operating the SBM-1 with the AC power
adaptor, the RMT-D7 is operational regardless of
whether the power of the SBM-1 is turned on or off.
RM-D3K
DAT deck,
digital
amplifier,
etc.
To (OPTICAL) I/O
To (COAXIAL) I/O
RM-D3K
SBM-1
Microphone
(not supplied)
Note
When using the optional
RM-D3K, operate this
tape-corder with the AC
power adaptor.
With the batteries,
wireless remote control
functions and digital
input/output connections
may not operate properly.
Note
When operating the
optional SBM-1 with AC
power adaptor, power is
supplied from this tape-
corder if the power of the
SBM-1 is turned off.
When this tape-corder is
operated with batteries,
disconnect the AC power
adaptor from the SBM-1
to conserve the battery.
Additional Information
( Additional Information
To Next Page
Loading...
Need help?
General
