Sony VPL-CS1 - Projecting

VPL-CS1
4-074-278-11 (1)
C:\MUN\Data\FM\VPL-CS1\VPL-
CS1.nouhindata\407427811VPLCS1WW\02GB-
VPLCS1WW\04SET.fm
masterpage:Left
21
GB
Projecting
Setting Up and Projecting
Projecting
1
Open the front cover, plug the AC power cord into a wall outlet, then
connect all equipment.
The ON/STANDBY indicator lights in red and the projector goes into
standby mode.
2
Press the
I
/
1
key.
The ON/STANDBY indicator lights in green.
3
Turn on the equipment connected to the projector.
4
Press the INPUT key to select the input source.
1)If you connect to both the S VIDEO and VIDEO jacks, the signal from the S
VIDEO jack is selected.
To input from Press INPUT to display
Computer connected to the INPUT A connector INPUT A
Video equipment connected to the video
1)
input
connector
VIDEO
RESET MENU POWER
INPUT
APA
POWER SAVING
ON/STANDBY
F
A
N
/
T
E
M
P
L
A
M
P
/C
O
V
E
R
ENTER
VOLUME
INPUT
FUNCTION
1
2
R.CLICK
1
5
6
2
4
2
4
Rear remote
control detector
ON/STANDBY indicator
APA key
VOLUME +/–
keys