19Projecting
Projecting the Picture
stops at the previously adjusted position
and adjusts the focus.
The projection size that can be adjusted
with the automatic focus adjustment is
from 40-inch up to 150-inch. However, it
may not be perfectly adjusted depending
on the brightness of the room, the state of
the screen or the use of the Side Shot. In
this case, adjust it manually in step 8 on
page 20.
3 Turn on the equipment connected to
the projector.
4 Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
• If “Auto Input Search” is set to “On,” the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
For details, see “Auto Input Search”
on page 31.
• The Smart APA is effective for the input
signal from a computer only.
5 Switch the equipment to be connected
to output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys
(e.g., , etc.), or by
changing your computer’s settings.
The key for switching the computer to
output to the projector varies depending on
the type of a computer.
6 Adjust the upper or lower position of
the picture.
To adjust using the Remote
Commander
Press the TILT/KEYSTONE key on the
Remote Commander to display the Tilt
menu and adjust the tilt using the M/m/
</, keys.
Note
To input from Press INPUT to
display
Computer connected to
the INPUT A connector
INPUT-A
Video equipment
connected to the VIDEO
input connector
VIDEO
Video equipment
connected to the S VIDEO
input connector
S-VIDEO
t
INPUT-A
t
VIDEO
t
S-VIDEO
Notes
Note
VGA
LCD
//
,
F7
Fx
Fn
or
and