To Next Page
D
Debbie HartmanAug 31, 2025
How do I stop the picture from flickering on my Sony VPL-CX80?
- CCory HillAug 31, 2025
To stop the picture from flickering on your Sony Projector, adjust the “Dot Phase” setting on the INPUT SETTING menu.
How do I stop the picture from flickering on my Sony VPL-CX80?
To stop the picture from flickering on your Sony Projector, adjust the “Dot Phase” setting on the INPUT SETTING menu.
Why is the picture on my Sony Projector not clear?
If the picture on your Sony Projector is not clear, first adjust the focus. If that doesn't solve the issue, condensation may have accumulated on the lens. Leave the projector on for about two hours to resolve this.
Why is the picture too dark on my Sony VPL-CX80?
If the picture from your Sony Projector is too dark, adjust the contrast or brightness in the “Adjust Picture...” menu, as described on page 29. If adjusting these settings doesn't help, the lamp may be burnt out or dimming, and you may need to replace it with a new one, following the instructions on page 37.
How to fix no picture on my Sony VPL-CX80?
If your Sony Projector displays no picture, ensure the cables are properly connected as described on page 17. If you're using a computer, and it's DDC compatible, connect the projector, turn it on, and then start the computer. Also, verify that you've selected the correct input source using the INPUT key, as shown on page 20. Check if the picture is muted by pressing the PIC MUTING key. Finally, make sure your computer signal is set to output to an external monitor as detailed on page 18.
What to do if both LAMP/COVER and TEMP/FAN indicators light up on Sony Projector?
If both the LAMP/COVER and TEMP/FAN indicators light up on your Sony Projector, it indicates a breakdown in the electrical system. In this case, you should consult with qualified Sony personnel for assistance.
How to adjust the image size on my Sony VPL-CX80 Projector when it extends beyond the screen?
If the image on your Sony Projector extends beyond the screen, and you've pressed the APA key when there are black edges, display the full image and press the APA key again. You can also adjust the “Shift” settings on the INPUT SETTING menu.
How to fix a Sony VPL-CX80 Projector when the power is not turned on?
If your Sony Projector isn't turning on, wait about 60 seconds before attempting to turn it on again if it was recently turned off and on. Ensure the lamp cover is securely closed and that the air filter cover is properly attached.
What to do if my Sony Projector has no picture?
If your Sony Projector displays no picture, ensure all cables are properly connected. Select the correct input source using the INPUT key. If using a computer, set the computer signal to output only to an external monitor. For notebooks or all-in-one LCD types, you might need to switch the computer's output to the projector via specific keys or settings; refer to your computer's operating instructions for details.
General