Hint
The above procedure is an example. For details, refer to the operating instructions supplied with your computer.
To delete all pairing information, see “Initializing the headset to restore factory settings.”
Note
If pairing is not established within about 5 minutes, pairing mode will be canceled and the headset will turn off. In this case, start
over from step 1.
Once Bluetooth devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
When a 9th device is paired.
The headset can be paired with up to 8 devices. If a new device is paired after 8 devices are already paired, the paired device
with the oldest connection time is replaced by the new one.
When the pairing information for the headset has been deleted from the Bluetooth device.
When the headset is initialized, all pairing information is deleted. In this case, delete the pairing information of the headset from
the Bluetooth device, and then pair them again.
The headset can be paired with multiple devices, but can only play music from one paired device at a time.
Related Topic
How to make a wireless connection to Bluetooth devices
Connecting to a paired computer (Windows 10)
Listening to music from a device via Bluetooth connection
Disconnecting Bluetooth connection (after use)
Initializing the headset to restore factory settings
4-729-821-11(2) Copyright 2018 Sony Corporation
If they are not connected, refer to “Connecting to a paired computer (Windows 10).”
If [WH-CH700N] does not appear on the display, try again from step 3.
A Passkey may be called “Passcode,” “PIN code,” or “Password.”
*
To Next Page
Loading...
