– 2 –
TABLE OF CONTENTS
1. GENERAL
Location of Controls ....................................................... 3
Resetting the Unit ........................................................... 4
Detaching the Front Panel............................................... 4
Setting the Clock ............................................................. 4
Using the Rotary Commander ........................................ 5
Installation ....................................................................... 6
Connections ..................................................................... 7
2. DISASSEMBLY ......................................................... 10
3. ASSEMBLY OF MECHANISM DECK........... 13
4. MECHANICAL ADJUSTMENTS ....................... 16
5. ELECTRICAL ADJUSTMENTS
Test Mode ........................................................................ 16
Tape Deck Section .......................................................... 16
Tuner Section .................................................................. 17
6. DIAGRAMS
6-1. IC Pin Function Description ........................................... 21
6-2. Printed Wiring Board – MAIN Section – ....................... 25
6-3. Schematic Diagram – MAIN Section –.......................... 29
6-4. Printed Wiring Boards – PANEL Section –.................... 33
6-5. Schematic Diagram – PANEL Section – ........................ 35
7. EXPLODED VIEWS................................................ 41
8. ELECTRICAL PARTS LIST ............................... 44
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
To Next Page
Loading...
Need help?
General
