Basic Operations
Basic Operations
11
3 Start recording.
To record from the CD player:
1 Press r/P and then (.
(On the remote, while keeping
r/P pressed, press TAPE
(.)
2 Press ^ to start playing the
CD tracks.
To record from the radio:
Press r/P and then (.
Note
On the player, press ( within 4
seconds after r/P is pressed.
Recording from the CD
player
Recording from the
radio
Tips
• To record on the reverse
side, use the 9 button
instead of
(
.
• Adjusting the volume or
the audio emphasis (see
page 39) will not affect
the recording level.
• When or is
displayed, recording will
be made on both sides of
the tape. To record on
one side, press DIR
MODE to display .
• If the AM radio makes a
whistling sound after
you’ve pressed
r/P in step 3, press
MODE•MONO/ST ISS
to select the position that
most decreases the noise.
Use these buttons for additional operations
To Press
stop recording p
pause recording r/P
Press the button again to
resume recording.
turn on/off the player POWER
To erase a recording, proceed as follows:
1 Insert a tape you want to erase its recording into the tape
deck and press p on the tape section.
2 On the player: press r/P and then (.
On the remote: While keeping r/P pressed, press ( on
the tape section.
pr/P
DIR MODE
MODE•MONO/ST ISS
POWER
To Next Page
Loading...
Need help?
General
