The Timer32
Timer-recording
radio programs
You can set timer to record the radio at
a certain time. You can also record the
sound of the component connected to
the LINE IN jack, using the timer. Make
sure you have set the clock (see “Setting
the clock” on page 28).
Before you begin, make sure the t (clock) indication
is not lit in the display. If it is lit, press STANDBY.
1 Tune in the radio station and insert a blank tape
into the tape compartment with the side you want
to record on facing up.
2 Press DIR MODE to
select recording
direction of the tape.
3 Press TIMER to display the t indication.
Do the following operations by checking the
display window.
4 Press TUNING TIME SET + or – to display
“RAdIO” “REC”, and press ENTER•MEMORY
CHECK.
Note
You cannot preset
recording timer and
waking up timer (page
29) at the same time.
Tips
• We recommend that
you use AC power as
the power source for
optimum recording
quality.
• When you receive the
AM program in step 1,
press r/P to check if
the noise is heard. If so,
press MODE•MONO/
ST ISS to select the
position that most
decreases the noise.
display
One side
Both sides
DIR MODE
STANDBY
TIMER
ENTER
MEMORY
CHECK
TUNING
TIME SET
+, –
To Next Page
Loading...
Need help?
General
