Additional Information42
Troubleshooting
General
Remedy
•
Press POWER to turn on the player.
• Connect the AC power cord to the AC IN socket
and a wall outlet securely.
• Make sure the batteries are inserted correctly.
• Replace all the batteries with new ones if they
are weak.
• Insert dry batteries. You cannot operate the
player on rechargeable batteries such as
rechargeable Ni-Cd batteries or rechargeable
Ni-MH batteries.
• Adjust the volume.
• Unplug the headphones when listening through
speakers.
• Replace all the batteries with new ones.
• Replace all the batteries with new ones if they
are weak.
• Make sure that the CD compartment is closed.
• Place the CD with the label surface up.
• Clean the CD.
• Take out the CD and leave the CD compartment
open for about an hour to dry moisture
condensation.
• Press p on the CD section to switch the function
of the player to “Cd”.
• Reduce the volume.
• Clean the CD, or replace it if the CD is badly
damaged
• Place the player in a location free from
vibration.
• Move the player away from the TV or radio.
•
Press MODE•MONO/ST ISS until “ST” appears.
• Depending on the FM reception conditions,
noise may be heard.
• Replace all the batteries with new ones if they
are weak.
• Move the player away from the TV.
• If you are using the remote while listening to
AM radio, noise may be heard. This is
unavoidable.
CD Player
Radio
Symptom
There is no audio.
The power is turned off
automatically.
Unusual sound is heard.
The sound is noisy, weak or has
poor quality.
The CD does not play.
“NO DISC“ lights in the display
even when a CD is in place.
The sound drops out.
When listening to the CD, the TV or
radio becomes noisy.
The audio is not stereo.
The audio is weak or has poor
quality.
To Next Page
Loading...
Need help?
General
