33
Settings
5.15 „Party Function“
With the party function the storage temperature is heated up once to the reference
temperature (TrefS3+hysteresis, respectively TecoS3+hysteresis in energy saving
mode). The party mode is activated by pressing the „esc“-key for 3 seconds in the
main menu. While this mode is active, the system heats up to the reference value +
hysteresis, unattached to preset thermostat times. The mode is ended once the re-
quired temperature is reached.
Party function is not activated by menu. The ESC key has to be pressed for 3
seconds.
During Energy saving mode, Party function heats up to TrefS3+hysteresis,
respectively TecoS3+hysteresis in Energy savings mode
Caution
Caution
5.17 TecoS3
Minimum temperature S3 in Energy saving mode
If the temperature at sensor 3 falls below this value and the thermostat function is ac-
tive (see 5.14 thermostat periods), additional heating via relais R2 is switched on until
TminS3 + hysteresis is reached (see 5.9 hysteresis).
Settings range : 0°C to 99°C / Default: 20°C
5.16 Energy saving mode
Energy saving mode for the thermostat function
In energy saving mode the additional heating via R2 is switched on at TecoS3 and
heats up to Teco+hysteresis. When energy saving mode is active, but no solar heat is
available, TsetS3 is used like in normal mode.
Settings range: On, Off/ Default: Off
To Next Page
Loading...
