Soundstream Tarantula Series User Manual

INSTALLATION PRECAUTIONS
Before you install the amplifier, investigate your car's layout very carefully. Take
special care when you work near the gas tank, fuel lines, hydraulic lines and electrical
wiring. Before making or breaking power connections in your system, disconnect
the vehicle battery. Confirm that your head unit or other equipment is turned off while
connecting the input jacks and speaker terminals. If you need to replace the power fuse,
replace it only with a fuse identical to that suggested by this manual. Using a fuse of a
different type or rating may result in damage to your audio system or your amplifier
which is not covered by warranty .
MOUNTING AMPLIFIER
1. Plan the installation of the amplifiers and find a suitable location with sufficient air
circulation.
2. Check the drawing below to mount the bottom amplifier.
Fig 4. Mount bottom amplifier

Soundstream Tarantula Series Specifications

General

Series	Tarantula
Category	Amplifier
Crossover	Variable Low Pass
Amplifier Class	D
Input Sensitivity	0.2V - 6V
Power Output	Varies by model
RMS Power @ 4 Ohms	Varies by model
RMS Power @ 2 Ohms	Varies by model
RMS Power @ 1 Ohm	Varies by model
Bridged RMS Power	Varies by model
Fuse Rating	Varies by model
Dimensions	Varies by model