General
Symptom
Power does
not turn on.
(No sound
is
produced.)
No sound
comes from
the unit
or
its
external
amplifier
Nothing
happens
when buttons
are
pressed.
Display is not
accurate.
Fuse is blown
Incorrect wiring
Wiring for amplifier
output is incorrect, or
there
is
a short circuit
among the output
wiri
The unit
is
in
MUTE
mode.
RCA output wiring is
incorrect
Wiring between
external amplifier's
REM terminal and the
unit's antenna lead
is
incorrect,
or
antenna
output lead
of
the unit
is
short circuit to round.
The microprocessor has
malfunctioned due to
noise, etc.
Panel or main unit
connectors
are d
Page -
13
Replace with a fuse
of
the same rating
amperage. If the fuse blows again,
consult ur local retailer.
Consult your local retailer.
Refer to the
un
it wiring diagram to
check proper connections, make sure
the wiring
is
done correct
ly.
Turn off the MUTE function.
Check and properly connect the RCA
output with the external amp
li
fier.
Properly connect the REM terminal
of
the external amplifier and the
un
it's
antenna output lead.
Turn off the power, Then press the [NO
OPEN] button and remove the
DCP.
Press the reset button for about 2
seconds.
Wipe the dirt off with a soft cloth
moistened with cleaning alcoho
l.
To Next Page
Loading...
