•
Clean only with a dry cloth or other similar materials.
• Install your product in a dry, well-ventilated location that does not interfere with your
vehicle’s safety equipment.
• Do not block any ventilation openings when installing this product.
• Do not mount the product in the engine compartment of your vehicle or in any areas of
apparatus.
• Securely mount the product so that it does not come loose in the event of a collision or
as a result of repeated vibrations that might occur during normal operation.
• Installation of the apparatus must be done with great care to prevent damage to your
vehicle’s fuel lines, power, and other electrical wiring, hydraulic brake lines, and other
systems. If possible always visit your nearest Nakamichi dealer to perform the installation.
• Do not run any wiring outside or underneath the vehicle. Keep all wires inside the vehicle.
• Take the necessary precautions when making connections to the vehicle’s battery to
avoid any potential shock.
• Protect all system wires from sharp edges by carefully routing them, always use rubber
grommets to protect wiring and cables whenever you are installing them through metal
openings.
• Secure all wiring using cable ties or wire clamps to protect them from moving parts and
INTRODUCTION
sharp edges.
liquids, shall be placed on the apparatus.
has been damaged in any way, such as the power input terminals are damaged, liquid
has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
• Fuses shall be replaced only with the correct type and fuse value, and only when the
apparatus is powered off.
• Exposure to high sound pressure levels may lead to permanent hearing loss. Take every
precaution to protect your hearing.
systems only. Using this product in systems with positive ground and/or voltages other
than 12V may result in damage to the product and your system.