Installer Setup - Automated Demand Response
33
ADR (setup step 51)
Controls whether you want the thermostat to possibly respond to
signals from the utility provider. Select ON to allow this and to have
steps 52-58 appear.
ADR Action (setup step 52)
Allows the user to determine what action is taken when an ADR
event is received.
Observe Setpoint Offsets – will offset the heat and cool setpoints by
the amounts specified in setup steps 57 and 58
Observe Static Setpoints – will set the heat and cool setpoints to the
values specified in setup steps 55 and 56
Event Max Cool Setpoint (setup step 53)
Event Min Heat Setpoint (setup step 54)
Specifies the range of allowable setpoint adjustments to be enforced
when any ADR signal has been received from the utility. Since
you might be paying more for energy while an event is active, you
can impose tighter limits on setpoint ranges that are only enforced
during the event.
Static Cool Setpoint (setup step 55)
Static Heat Setpoint (setup step 56)
Specifies the setpoints that will come into use during an event when
the ADR ACTION is set to OBSERVE STATIC SETPOINTS.
To Next Page
Loading...
