Source Audio Artifakt Lo-Fi Elements User Guide
Mono In, Stereo Out
This is a very common use case that allows you to create some nice stereo imaging from a
single mono instrument input or use your Artifakt as a splitter to send your signal to two
separate outputs. When the unit is bypassed in this mode, it will automatically switch to
Soft Bypass mode to maintain the bypass signal on the Channel 2 output. When Ch. 1 and
Ch. 2 are linked, the output will be the same for both channels. When they are unlinked,
you can configure separate settings for Channel 2.
To Next Page
Loading...
