Source Audio Artifakt Lo-Fi Elements User Guide
Troubleshooting
Restore Factory Settings
To revert the Artifakt to its factory settings, clearing all user data, presets, expression
mappings, and changes to the MIDI mapping, use either the Neuro Mobile App or Neuro
Desktop Editor and choose the Factory Reset option in the Hardware Options menus. It is
also possible to perform a factory reset without the Neuro App by following these steps:
§ Press and hold the ON/OFF FOOTSWITCH.
§ Connect the power supply.
§ The CONTROL LED will blink rapidly until the reset is complete. You can stop holding
the FOOTSWITCH once the CONTROL LED starts to blink.
Noise & Hum
Power source: Ensure that the proper power supply is being used.
Near noise source: Move pedal away from power supplies and other equipment.
Other equipment: Remove other effects from signal chain; see if noise persists.
Bad cables: Swap out audio cables.
USB ground loop: When connected to a computer using a USB cable, noise can appear in
the audio signal. This usually results from ground loop noise due to the Artifakt and
computer running on separate power supplies. In the case of laptops, disconnecting the
computer’s power supply and running it on a battery can often mitigate the noise. External
display monitors are often the primary source of noise and powering down monitors can
also resolve noise issues.
Ground loop with amp: Make sure your Artifakt is running on the same power mains
circuit as your guitar amplifier.
PRESET: Check your Artifakt preset. Many lo-fi element blocks in the Neuro editor contain
purposeful noises & hums!
Unit Appears Dead / No LEDs Lit
Wrong power supply: Use correct power supply. See the DC 9V (Power) section for more
details.
To Next Page
Loading...
