Name: South-Tek Systems N2-BLAST FPS-500
Brand: South-Tek Systems
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Version: 1

Revision Date: 02/2018

2-BLAST

FPS-500

O&M Manual

Page: 9 of 25

RECEIVING, UNPACKING, AND STORAGE INSTRUCTIONS

3.1 UNPACKING AND PREPARATION

The N2-BLAST

FPS-500 will arrive in a cardboard box. Open the box carefully, and

identify and verify all parts listed on the packing list are present and undamaged.

South-Tek Systems (STS) is not responsible for damages that occur during shipping

and handling of the N2-BLAST

. Document any visual damages and report them to

the responsible shipping company, and then, contact STS at (888) 526-6284 to

assess the damages.

Until Installation:

• Store the N

2-BLAST

in a dry and climate controlled (60-80° F) room.

• Always keep N

2-BLAST

in an upright position / or, preferably, in the box as shipped.

• Read entire manual and make all connections (per instructions) before connecting power.

• Keep all gas lines dry so moisture does not enter generator upon hookup.

• Never place/stack objects on top of the N

2-BLAST

Remove the nitrogen generator from the cardboard box by carefully lifting the unit out and setting

it on the flat surface. Prepare the wall mounting bracket before moving it to the nal location.

Note: Remove the 4 painted bolts below the cabinet to free up the compressor’s

vibration isolators.

Carefully, break down the cardboard box and store in a safe location. Reuse the cardboard box if

returning for factory service.

Figure 1: Remove shipping bolts

Remove these 4 bolts

underneath the cabinet prior to

starting up the unit

South-Tek Systems N2-BLAST FPS-500 User Manual

Other manuals for South-Tek Systems N2-BLAST FPS-500