SP Controls PixiePro PX2-MP-IR - Page 17

To Erase a Single Button
WhileinLearningMode,pressandholdabuttonthathasbeenprogrammedtoeraseit.Thebutton
willbeginblinkingslowlytoindicatethatitisgoingtobeerased.Blinkingwillgraduallyquickenand,
afterseveralseconds,thebuttonwillgodarkandbeepfourtimestoindicatethaterasureiscom-
plete.
To Erase All Buttons on the TCM only
PressandholdanytwobuttonsonthePixieProTCMwhilethePixieProisinLearningModeto
erasetheTCMsection.TheTCMbuttonswillbeginblinkingslowlytoindicatethatitisgoingtobe
erased.Blinkingwillgraduallyquickentoconfirm TCM erase.Afterafewseconds,allbuttonsonthe
TCMwillgodarkandthePixieProwillbeepfourtimes,indicatingthattheTCMhasbeenerased.
Onceadeviceorbuttonhasbeenerasedthereisnowaytoun-eraseit.
IfthePixieProisconfiguredtouseMultiple-DevicemodefortheTCM,thiswillerasethelast-select-
ed device only.AnyothercodesetsprogrammedtotheTCM,andcodesprogrammedtothe
PixiePro,willnotbeerased.
To Erase All Buttons on PixiePro, including all TCM codes
WhileinLearningMode,pressandholdanytwobuttonstoerasetheentiredevice.IfthePixieProis
configuredtouseMultiple-DevicemodefortheTCM,atleastoneofthebuttonsmustbeoutsideof
thatmoduletoerasetheentiredevice(e.g.,oneofthesourcebuttonsorpowerbuttons).
Thewholebuttonpadwillbeginblinkingslowlytoindicatethatitisgoingtobeerased.Blinkingwill
graduallyquickentoconfirm device erase.Afterafewseconds,allbuttonswillgodarkandthe
PixieProwillbeepfourtimesindicatingthatithasbeenerased.Allcodesetsprogrammedtothe
TCMwillbeerasedalongwiththeotherbuttons.OncethePixieProhasbeenerasedthereisno
way to un-erase it.
Configurationsettingswillnotbechangedbydeviceerase.
14