Spa-Quip SP400P User Manual

3.3 Pump 1 (Two speed, no 24HR circulation pump fitted)
Page 4
Push 1 (Manual Low Speed)
Push 2 (Manual High Speed)
Push 3 (Standby Mode)
Push 4 (Auto mode)
HEATHEAT PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR
HEATHEAT PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR
HEATHEAT PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR
HEATHEAT PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR
Push 1 (Low Speed)
Push 2 (High Speed)
Push 2 (Pump off)
HEATHEAT PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR PUMP
H20
AIR
HEATHEAT PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR PUMP
H20
AIR
HEATHEAT PUMP AUTO AIR PUMP AUTO AIR PUMP AUTO AIR PUMP
H20
AIR
Pump 1 is controlled by just one touch pad button pushing the pump button 4 times cycles its operation through 4
modes Automatic, Manual Low Speed, Manual High Speed and Standby. When the spa is running in automatic
mode, pressing the pump 1 button will deactivate auto mode and set the pump running in Manual low speed. The
auto LED is orange when auto mode is enabled and off when in manual low speed or manual high speed. When
the pump is in standby mode all indicator LED's are off.
Notes:
1) If Pump 1 is left in ”Manual or “Standby” modes, it will automatically revert to “Auto” mode after 90 minutes.
2) There is no direct user control over the heater. The heater may come on automatically whenever Pump 1 is on.
3) If the heater element is on, running the pump in high speed may cause the heater to load shed and switch off.
Pushing the pump button three times cycles the pump through its two speeds then off. The pump LED is green
when the pump is running in low or high speed and off when pump is off.
Notes:
1) If Pump 1 is left on, it will automatically switch off after 20 minutes.
2) There is no direct user control over the heater. The heater may come on automatically whenever the 24hr
circulation pump is on.
3) If the heater element is on, running the pump in high speed may cause the heater to load shed and switch
off. If this occurs the heater will come back on approximately 5 seconds after the pump is deselected.
3.4 Pump 1 (Two speed, 24HR circulation pump fitted)

Spa-Quip SP400P Specifications

General

Brand	Spa-Quip
Model	SP400P
Category	Controller
Language	English