Report Number : TEC135
Issue : Two
Date : Mar 2006
Page : 8
Electrical
1. The spa pool must be connected to a suitable weather protected supply, equipped
with a double pole isolating switch, which is of the correct rating and complies with
the local wiring regulations. When installing refer to your local wiring code. In
particular refer to ECP2 and ECP25 (AS / NZ). Or EN 60364-4-1 and EN 60364-7-1
(EU). The system must be installed in such a way that live parts are not accessible
by a person in the pool.
2. Ensure the system is protected by an RCD.
3. It is recommended that signal and power wiring be separated to prevent interference
and that the unit is supplied from a dedicated power circuit.
4. Loop wires before they enter the unit to prevent water running down them and into
the unit.
5. Check all connections are correct and tight.
6. Check that the unit and supply are not overloaded. Use the loading calculator for
details.
To Next Page
Loading...
