e. Rotate draw valve to lock ice buster in place; turn valve unl the hole for the draw handle is
accessible on front.
f. Insert draw handle; secure in place with valve pin.
g. Screw prime plug onto dispensing door.
h. Place dispensing door gasket on door, coang with Spaceman lubricant; Place beater guide onto
dispensing door, with ange ush with the back of the door.
i. Align door assembly with torque assembly and mounng bolts; install dispensing door unl ush
with machine; if needed, gently wiggle dispensing door to get the beater guide to line-up correctly
inside the beater; DO NOT force the dispensing door onto the machine.
j. Tighten dispensing door hand-screws (4) in a cross-paern.
k. With tapered end down, install torque arm up through the sensor pin hole under the overhead and
then down into the torque assembly; torque am should move freely back and forth.
a. If machine has hopper agitator,
lubricate inside it and install with arrow
poinng up.
b. Install hopper lid and drip trays (internal
and front).
To Next Page
Loading...