Spaceman 6455-C - Routine Maintenance

• Daily
•: Every 1 to 3 months*
• Quarterly**
* Based on machine usage and cleaning intervals; a Tune-Up Kit is available with all
wearable parts (O-rings, gaskets, etc.) except scraper blades
** Based on cleanliness of locaon and proximity to powder-based machines.
Preventave maintenance includes cleaning condensers, checking belt tensions, and
cleaning the interior of the machine frame as required.
For opmal machine performance and many years of eciency and reliability
from your machine, Spaceman recommends cleaning and sanizing the
machine and its parts . The machine comes equipped with a brush kit
specically designed to eciently and properly clean the machine.
Cleaning and sanizing schedules are governed by state or local regulatory agencies
and MUST be followed accordingly. Roune maintenance MUST be performed a minimum of once
every 3 days.

• Do NOT run the machine without properly lubricang required parts
• Do NOT clean the machine with abrasive or toxic chemicals and cleaners. Doing so may cause
damage to the stainless steel material
• ONLY use Spaceman-included cleaning brushes and lubricaon
• NEVER use metal objects to clean or operate the machine
• ALWAYS replace wearable parts a minimum of every 3 months
• ALWAYS prime machine prior to operang
• ALWAYS inspect parts for excess wear and damage
Addional brushes, lubricaon, wearable parts, and tools can be purchased from Spaceman
to ensure proper maintenance. Extra wearable parts (except scraper blades) are found in the Start-
Up Kit.



If this is the rst me operang the machine, you MUST clean and sanize ALL parts
prior to running the machine.
The image displayed is for illustraon
purpose only and may dier from the
actual product.
-