Never force the installaon of any parts. All parts t correctly without force. If parts
don’t seem to t, remove all parts and repeat assembly.
a. Place drive sha gasket on drive sha.
b. Seal gasket open space with Spaceman lubricant,
extending onto drive sha and avoiding the top square
part.
c. Insert drive sha into rear shell bearing at the back of
the cylinder, and turn it unl the key engages rmly into
the socket (when inserted correctly, the drive sha will
no longer turn 360°).
a. Place torque guide onto the end of the beater assembly; DO NOT lubricate this component.
b. Place O-ring on torque assembly, coang with Spaceman lubricant.
c. Insert torque assembly into torque guide at the end of beater assembly.
d. Fit scraper blades onto beater.
e. Insert the complete beater assembly into cylinder; turn assembly unl it engages the drive sha
key and no longer turns 360°.
a. Place O-rings (2) on draw valve, coang with Spaceman
lubricant.
b. Insert draw valve 7/8 way into the dispensing door from
the top, rotang as you install.
c. Turn draw valve so the at poron at the valve top is
perpendicular to the clear face of the dispensing door .
d. Insert ice buster through the dispensing spout at the
boom of the door and into the slot on the draw valve.
To Next Page
Loading...