Spaceman 6455-C - Page 16



1. Inadequate mix in hopper.
2. Improper mixing of product.
3. Torque arm is not installed correctly.
4. Viscosity adjustment is set incorrectly.
5. Le/right sensor not engaging and/or is
stuck to the le.
6. Up/down sensor is engaged and stuck in up
posion.

1. Ensure hopper is at least half full.
2. Follow manufacturer instrucons for mixing.
product; ensure correct mix raos.
3. Install torque arm on dispensing door.
4. Lower viscosity seng as required (Page 13).
5. Verify sensor arms are installed and
operang according to the manual







1. Improper mixing of product.
2. Missing, damaged, or incorrectly installed
scraper blades.
3. Viscosity adjustment is set incorrectly.
4. Beater is rotang counter-clockwise.

1. Follow manufacturer instrucons for mixing
product; ensure correct mix raos.
2. Inspect scraper blades for damage and correct
installaon.
3. Increase viscosity seng as required (Page 13).
4. Call Spaceman Technical Support.

1. Machine is unplugged.
2. Tripped circuit breaker or blown fuse.
3. Machine has tripped safety reset.

1. Verify machine is plugged into power source.
2. Verify and reset circuit breaker and/or fuse.
3. Reset machine (Page 13).

Machine has tripped safety reset due to motor
overload.

Reset machine (Page 13).
Check sensor arms.

1. Lubricaon on square ends of drive sha.
2. Scoring due to lack of lubricaon.

1. Do NOT lubricate the square end of the drive
sha; contact Spaceman Technical Support for
instrucons on removing and inspecng drive
sha and gear box for damage.
2. Replace Drive Sha, use addional lubricaon.
