12
ARMED INDICATOR LED
Please note this is an optional fitment, providing an additional
visible deterrent to car thieves. The alarm will still function
correctly if you choose not to in stall th e LED. To install follow
the instructions below.
• Decide on a suitable location to mount the LED. We would suggest using one of
the blanking plugs found on most modern cars, or the plastic casing surrounding
the ignition barrel or steering column.
• Ideally remove the blanking plug or plastic casing arou nd the ig n ition
barrel/steering column before drilling a 7.5mm hole to site the LED bezel.
• Unscrew the bezel from the LED wire and insert the bezel into the drilled hole from
the front, before securing at the rear with the locknut provided.
• Route the LED wiring carefully from the alarm, through an existing b ulkhead
rubber grommet and up to the area where the LED will be sited.
• When the wiring is safely secured screw in the L ED into the bezel and insert the
connector into the alarm.
• Refit the blanking plug or plastic casing around the ignition barrel/steering column.
PURPLE AND GREY WIRES -IN DICATORS
PURPLE (R/H): Using the vehicles wiring diagram or with
the aid of a 1 2 volt test lamp, locate the wire at the indicator
switch which illuminates the test lamp when the RIG HT
indicator flashes. Connect the PURPLE wire to this wire
using a solder joint, crimp termination’s or an IDC
connector.
To Next Page
Loading...
