20
TESTING THE ALARM INSTALLATION
1) Check all connections are secure and the ve hicle battery is connected.
2) Ensure the car ignition is turned off.
3) Press the remote control button. The alarm will disarm with one chirp and one
flash of the indicators.Press the remote control button. The alarm will disarm
with two chirps and two flashes of the indicators.
4) Arm the alarm. Wait approximately 20 seconds, open a door ensuring interior
light operates. The alarm will trigger. Disarm the alarm. (Refer to trouble
shooting section if alarm fails to trigger).
5) Repeat the arming proced ure and trigger via shock sensor. Disarm alarm.
6) Repeat the arming procedure and trigger the alarm b y op ening the door.
Alarm will sou nd. Now attempt to start vehicle (Vehicle starter motor should
NOT operate whilst the Alarm Siren is soundin g).
Test remote panic features by holding down t he remote control button for 3 seconds.
The alarm will trigger. Release button and press again to disarm the alarm. If
problems are encountered, refer to trouble shooting guide before proceeding further.
Once the alarm has been successfully tested you may now secure the ultrasonic unit
in place
To Next Page
Loading...
