6
PASSIVE ARMING/CURRENT SENSING DISABLE
PASSIVE ARMING
Passive arming is a feature whereby the alarm will automatically “arm” a short time
after the last door on the vehicle has been closed.
Disarming the alarm is achieved by pressing the remote control button or by turning on
the vehicle ignition. To switch ON th e passive arming feature, move switch number
TWO located on the rear of the alarm to the ON position, as sho wn on page 11.
IMPORTANT NOTE: If passive arming is selected, when the last door of
the vehicle has been clo sed, the LED will flash for 15
seconds followed by one chirp from the siren. The
LED will then light continuously for 1 5 seconds, then
revert to flashing mode to indicate the alarm is fully
armed.
CURRENT SENSING DISABLE
If the vehicle has any electrical accessor y which draws power from the b atter y when
the vehicle is parked i.e. car telepho ne, electro-mechanical, mechanical clock, (pre
1980). It will be necessary to disable the current sensing feature to reduce the risk of
false alarms.
This is done by ensuring switch numb er O NE is in the downward s (OFF)
position-see page 11
To Next Page
Loading...
