MAINTENANCE 25
There are no user-repairable parts in the Sparx®
Sharpener. Refer to “Exclusions” in the Warranty
section for more information. Maintenance of the
Sparx® Sharpener is limited to the procedures
outlined in this section.
REMOVING AND EMPTYING
THE DUST TRAY
To watch the How-To video, visit sparxhockey.com/dusttray.
Maintenance Frequency: Perform the following steps after every 20
Sharpenings (160 cycles on any of the following: Radius Ring®, FIRE
Ring®, or X-Grind Ring) and before moving and/or traveling with the
sharpener.
1 REMOVE AND EMPTY THE DUST TRAY
Open the Glass Door and remove the Dust Tray. To empty Dust
Tray—wipe completely clean with a damp cloth (water).
Do not use any solvents or cleaning chemicals in and
around the Skate Sharpener.
2 VACUUM SHARPENER
After removing the Dust Tray, vacuum throughly around the inside of
the sharpener. Detach the vacuum hose from the port on the side of
the machine and use the supplied attachments for this purpose.
3 REPLACE THE DUST TRAY
Slide the Dust Tray back into the machine. Close the
Glass Door.
6
MAINTENANCE
To Next Page
Loading...
