SpeakerCraft CS3 User Manual

CS3 IR REMOTE CONTROL
1. POWER - Press this button to turn the CS3 ON/OFF. (Power
switch on the CS3 rear panel must be in the ON position.)
2. INPUT - Press to select a connected source. The CS3 Front
Panel Status
LED will flash once to indicate a change in input
selection.
*
COAX- Press to select the Digital Coaxial Input.
OPT - Press to select the Digital Optical Input.
AUX - Press to select the L&R Line Level Audio Input.
~ - Press to select a paired Bluetooth device. A Bluetooth
device must be paired to the CS3 for audio output. A
paired Bluetooth device will remain 'connected' after
changing inputs as long as the Bluetooth device has
not moved out of range, turned off or otherwise discon -
nected .
3. cooE - Press this button to initiate Bluetooth pairing mode. The
Front Panel Status
LED will rapid flash blue . The CS3 will output
a pairing code that will be picked up by any active Bluetooth
device that is within range of the CS3. See section: Pairing A
Bluetooth
Device for additional information .
4. VOLUME -/+ Press VOL- to reduce volume. Press VOL+ to
increase volume.
5. BASS -/+ Press BASS- to reduce low frequency output. Press
BASS + to increase low frequency output.
6. TREBLE -/+ Press TREBLE- to reduce high frequency output.
Press TREBLE+ to increase high frequency output.
7. MUTE- Press this button once to mute the CS3, (no audio out -
put from the speakers). Press this button again to un-mute the
CS3 , (audio output from the speakers).
8. SURR- Press this button to activate the simulated surround
audio mode. Press again to turn Surround Mode OFF.
9. EQ RESET- Press this button to cancel any changes to the
Treble and Bass controls.
Remote Control Battery Replacement CAUTION:
1--~
2-~
3-~
4--~ ·
5---~
6-~
CS3 FEATURES
~...,__-8
.....-t---4
~""""-~+-----9
@ SpeakerCraft
WHEN REPLACING THE LITHIUM BATTERY IN THE REMOTE, MAKE SURE THAT THE REPLACEMENT BATTERY IS INSERTED
IN CORRECT POLARITY. PLACE THE BATTERY SO THAT ITS POSITIVE(+) SIDE FACES UP WITH THE TRAY HELD SO THAT
THE SURFACE WITH THE DOT AND (+) IS FACING UP.
Remote Control Battery Installation
Push small tab toward
battery slot.
Pull battery drawer out .
In sert battery with "+" s ide up,
and sl i de drawer ba ck i nt o re mo te.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE (CR2025).
WARNING:
DO NOT EXPOSE BATTERIES TO EXCESSIVE HEAT SUCH AS DIRECT SUNLIGHT, FIRE OR THE LIKE.
DISPOSE OF DEAD BATTERIES IN ACCORDANCE WITH LOCAL REGULATIONS.
9

SpeakerCraft CS3 Specifications

General

Brand	SpeakerCraft
Model	CS3
Category	Speakers
Language	English