Speck BADU - Drainage; Risk of frost; Safe use of the product

Safety
12 EN 08|2018
2.9.7 Drainage
An insufficient drain gap can damage the motor.
 Do not block or seal the drain gap between the pump
housing and the motor.
2.9.8 Risk of frost
 Drain the pump/unit and pipes at risk of freezing in plenty of
time.
 Remove the pump/unit during periods of frost and store it in a
dry room.
2.9.9 Safe use of the product
Safe use of the product is no longer guaranteed in the following
instances:
 If the pipework is not in proper condition.
 If the pump seizes. See point 2.8 on page 10.
 If protective devices are damaged or missing, e.g. protection
against accidental contact.
 If there is stress on the pump/unit or pipes during installation.