Speco D8RS - Device; Display

71
7-7-3. Device
Select Device to set Spot Out, Enable/Disable CVBS Out, motion zone.
 ALARM OUT: Set the sensor, motion, and video loss for triggering alarm relay HDD Error and
Video Loss can trigger beeping.
 CONTROLLER: Set the controller baud rate and ID.
 PTZ: Set the PTZ baud rate, protocol, and ID.
 MOTION: Setup the motion detection area and the sensitivity.
o SITE: Select the channel
o MOTION ZONE: FULL Zone or PARTIAL Zone
o MOTION SENSITIVITY: 1~9 (High sensitivity level)
 KEYTONE: Sets On or Off of Key Tone.
 REMOTE CONTROLLER ID: Sets an ID number on the supplied remote control for its identification.
 SENSOR: Select the type of each sensor.
7-7-4. Display
Select the DISPLAY tab to set the DISPLAY conditions.
These settings apply to all channels.
 OSD: Sets whether to display or not date and time as well as channel number on the screen.
 OSD CONTRAST: Adjust the character contrast on the screen.