Speco DVR-4TN - System Date; Time Setting

User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/08
26
Move the cursor up/ down over the OSD items using the Direction keys and
press ENTER to enter the selected sub-menu.
3.5 System Date/ Time Setting
The user can set the current date, time and other OSD parameters in the
Date/ Time menu. The administrator’s privileges are required for entering the
submenu. In the OSD Main menu, select <System Setup> and press ENTER,
then select <Date/ Time> to access the Date/ Time menu; the menu displays
as follows.
Date/ Time
1. Date
2. Time
3. Time Zone
4. Date/ Time Display
5. Date Display Mode
6. Time Display Mode
7. Date/ Time Order
8. Daylight Saving Time Setup
9. Network Time Protocol Setup
2005/02/21
PM10:39:26
OFF
1 Row
Y/M/D
24 HR
Date First
3.5.1 Set Date/ Time
Set Date/ Time
Select <Date>/ <Time> and press ENTER to adjust the settings. LEFT/
RIGHT keys are used to move the cursor to previous or next field, ENTER is
for selecting, and UP/ DOWN are used to change the value in the selected
field.
NOTE: The reset date/ time setting applies for recording new video,
the date and time of previously recorded video will not be changed.
NOTE: To avoid record database corruption, after changing the date/
time setting, it is recommended to clear the database.
Date/ Time Display
Users are allowed to choose to set the date/ time OSD displays in 1 or 2 rows.
Use the UP/ DOWN keys to change the setting. The default is to display the
date/ time OSD in one row.