To create a motion or mask window, follow steps:
1. Click the right button of mouse to see the mouse menu.
2. Select New Motion (or Mask) Window in the mouse menu.
3. Click and drag mouse to designate a motion area.
• Motion Detection Setting
The behavior for each window is defined by adjusting the Threshold and Sensitivity, as described
below.
A motion index is a set of parameters describing Window Name, Type, Threshold, Sensitivity, and
Dwell Time. Window Types is one of Motion and Mask windows.
- Threshold: Sets up the threshold for the motion detection.
- Sensitivity: Sets up the sensitivity for the motion detection.
- Dwell Time: Set the hold time an event lasts for the specified hold time from the point of
detection of a motion.
You can also modify or delete a motion index. Select an index and then, click the Modify or Delete
button.
Select “Enable” to activate the motion window.
33
To Next Page
Loading...