EasyManua.ls Logo

Spectra Precison GL1425C - Battery Indication; Recharging the Batteries; LED Indication on the Charger

Spectra Precison GL1425C
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Close the battery door.
3.4.2 Battery indication
WHY: Displays the battery status prior to starting work on the job site.
WHAT: The battery indication shows the remaining battery capacity for the rechargeable
or alkaline batteries. Actual capacity depends on battery brand, environmental factors,
age, and recharge cycles.
HOW: When the laser battery LED (b) is o, the battery capacity is good. Blinking once
every second indicates the batteries are weak and remaining operating time is limited.
The batteries should be charged. A quickly ashing battery LED indicates the batteries
are empty and remaining battery capacity of 5 minutes. Times may vary depending on
environmental factors.
On the RC1402 or on the laser on the standard display press the E button (j). The
battery symbol will appear and is shown on the screen for app. 5 seconds. The symbol
represents relative battery capacity: Empty, almost empty, good, and full. (pic 1)
Pic 1: battery symbols
3.4.3 Recharging the batteries
It typically requires less than ten hours to fully charge empty rechargeable batteries.
For charging, connect the plug of the charger to the recharge jack of the battery pack.
Plug the charger into the appropriate outlet. The battery pack can be charged in or out
of the laser.
New or long-time out-of-use rechargeable batteries reach their best performance after
being charged and recharged ve times. For indoor applications, the charger can be
used as a power supply for the laser.
3.4.4 LED indication on the charger
Green LED ashes: charging in progress
Green LED permanent on: charging has stopped
Red LED permanent on: Error (batteries too cold or too warm, battery failure etc.)
Note: The batteries should only be charged when the temperature is between 41°F and
104°F (5°C to 40°C). Charging at temperature other than specied may give an error
indication.
Note: The charger has a security timer. The maximum charging time is twelve hours.
After twelve hours, the charger will always stop the charging process, independently
from the charging status of the batteries.
Note: The batteries can be charged during use.

Table of Contents

Related product manuals