Spectra Precison GL1425C - Sensitivity; Language

24
17.6 Sensitivity
WHY: The job site conditions might be dierent as well as the requirements according
to accuracy. On some job sites there are a lot of vibrations caused by machines there
is a lot of wind.
WHAT: The GL1425C provides dierent levels of sensitivity depending on the job site
conditions. In all levels of sensitivity the laser will level to the most accurate level or
grade value. Nevertheless the tolerance allowing for a disturbance by vibration or
wind will be dierent. The three dierent levels of sensitivity provided by the GL1425C
are low to work with high wind and vibrations, middle to work under normal job site
conditions (default) and high to work in very calm conditions.
HOW: Press M button (h) to enter the menu, scroll to >>Settings<< and press E button
(j) to enter the sub menu. Scroll to Sensitivity and press E button (j) again to enter the
sub menu. Choose the desired level of sensitivity Low, Middle(default), or High.
>>Low<<
>>Middle<<
>>High<<
17.7 Language
WHY: The laser is used worldwide or the company using the GL1425C may have
employees from dierent countries. Each person on a job site using the GL1425C
wants to use the laser in the known language.
WHAT: The GL1425C provides many dierent languages for the interface. Standard
language is English. Using the laser remote app with the laser, there is no need to
change the language for the app. The laser remote app will use the language that is
used for the smart phone when this language is supported by the laser. If the smart
phone uses a language that is not supported by the laser, the laser remote app uses
English as the language.
HOW: Press M button (h) to enter the menu. Using Up/Down buttons (f) scroll to
>>Language<<. Press E button (j) to enter the sub-menu. Scroll to the language,
select the language moving these >> << symbols by scrolling and press E button to
conrm.
>>English<< >>Deutsch<<
>>Italiano<< >>Francais<<
>>Portugues<< >>Nederlands<<
>>Dansk<< >>Norsk<<
>>Svenska<< >>Suomi<<
>>Polski<< >>Turkce<<
>>Cestina<<
17.8 Radio Channel
WHY: The laser GL1425C is using radio communication between the laser and the
remote control and the laser and the receiver HL760/CR700. On some jobsites there
can be radio pollution within the radio channels. When the radio communication is
not working properly, one solution can be to change the radio channel and use a radio
channel that is more open.