Spectra 1759ex - Arming and Disarming; Timed Auto-Arming

Spectra 1759EX - 24 - Programming Guide
WIRELESS EXPANSION ZONE PROGRAMMING
ZONE ASSIGNMENT
The ser ial n um ber can be located on the inside of the transmitter or you ca n use the Serial Number Display feature (see
page 24). Also, refer to “Zone Recog nitio n Ta ble ” on page 6 .
Section # Ser ial #
[601] ___/___/___/___/___/___= EXPA NSION IN PU T 1
[602] ___/___/___/___/___/___= EXPA NSION IN PU T 2
[603] ___/___/___/___/___/___= EXPA NSION IN PU T 3
[604] ___/___/___/___/___/___= EXPA NSION IN PU T 4
[605] ___/___/___/___/___/___= EXPA NSION IN PU T 5
[606] ___/___/___/___/___/___= EXPA NSION IN PU T 6
[607] ___/___/___/___/___/___= EXPA NSION IN PU T 7
[608] ___/___/___/___/___/___= EXPA NSION IN PU T 8
Bold = Default Setting
SERIAL NUMBER DISPLAY
Section # Description
[630] Press the tamper switch of the Omnia Wireless Transmitter. The keypad will emit a confirmation beep. On
LED keypads, press the [ENTER] key to view the digits one at a time. On LCD keypads, the first 3 digits of
the serial number will appear. Press the [ENTER] key 3 times to view the next 3 digits. Continue activating
the desired transmitters or press [CLEAR] to exit.
SIGNAL STRENGTH DISPLAY
Section # Description
After entering the desired section, activate the Omnia Wireless Transmitter by opening/closing the zone
or by pressing the tamper switch. Always ignore the first reading as it won’t be accurate. An average
re ading of 3 an d up is acce ptable.
[631] Display Signal Strength of Expansion Input 1 - Section [601]
[632] Display Signal Strength of Expansion Input 2 - Section [602]
[633] Display Signal Strength of Expansion Input 3 - Section [603]
[634] Display Signal Strength of Expansion Input 4 - Section [604]
[635] Display Signal Strength of Expansion Input 5 - Section [605]
[636] Display Signal Strength of Expansion Input 6 - Section [606]
[637] Display Signal Strength of Expansion Input 7 - Section [607]
[638] Display Signal Strength of Expansion Input 8 - Section [608]
SECTION [610]: GENERAL OPTIONS
Op tion OFF ON
[1] Wireless transmitter check-in supervision N Disabled N Enabled
[2] Check-in supervision base time setting (must
be same as the transmitter’s jumper setting)
N Hours N Minutes
[3] & [4] Future use N N/A N N/A
[5] Check-in supervision time value (must be same
as the transmitter’s jumper setting)
N 12 N 6
[6] Future use N N/A N N/A
[7] Future use N N/A N N/A
[8] R emote contro l assi gnme nt mo de N Omnia (OMN-R CT1) N ParaKey (LIB- 344)