Spectra T200 - Page 12

Replacing the Fan Assembly Replacing a T200, T380, or T680 Fan Assembly
November 2013 Spectra T200, T380, T680, T950 and T-Finity libraries
12
c. Fitthealignmentpinonthetopedgeofthepanelandthetwonuts
extendingfromthebackofthefrontpanelintothecorresponding
holesontheedgesofthechassis.
Note: Makesurethatthepowerbuttonfitsintothecutoutinthefront
panelandthatthefrontpanelisflushagainstthefrontofthe
chassis.
2. Usingyourfingersora#2Phillipsscrewdriver,tightenthetwoknurled
screwsonthebottomofthelibraryfrontcovertosecureittothe
chassis.
Figure 7 Front panel attachment.
Figure 8 Front panel screws.
Alignment
Chassis
Library Front
nut on
front panel
Knurled
screws
Library Front
Slots for
filter cover