Spectra T200 - Remove the Front Panel

Replacing the Fan Assembly Replacing a T200, T380, or T680 Fan Assembly
November 2013 Spectra T200, T380, T680, T950 and T-Finity libraries
8
3. BackPanel—DisconnecttheACpowercordsfromthelibrary.
Note: Ifcablelocksareinstalledonthepowercords,itmaybeeasierto
disconnectthecordsfromtheACoutletsatthewall.Ifyouhave
redundantpowersuppliesinstalled,makesureyoudisconnect
bothpowercords.
Remove the Front Panel
Followthesestepstoremovethefrontpanel:
1. Fromthefrontofthelibrary,pullfirmlyoutwardonthetopedgeofthe
filtercoverpaneltoreleasethemagneticlatchesandtipthecoverout
fromthefrontpanel.
2. Liftthecoverupwardtodisengagethetabsoneachsideofthecover
fromtheslotsinthefrontofthelibrary.Setthecoveraside.
Figure 2 Filter cover panel removal.
1. Pull outward
2. Lift upward
Tab
Library Front