Spectra T200 - Replace the Front Panel

Replacing the Fan Assembly Replacing a T200, T380, or T680 Fan Assembly
November 2013 Spectra T200, T380, T680, T950 and T-Finity libraries
11
5. Angletherightedgeoftheassemblybehindthefrontrightedgeofthe
chassissothatthenotchesintheedgeoftheassemblyfitoverthePEM
nutsonthechassis.
6. Pivottheleftsideofthefanassemblyintowardthelibrary.
7. Usingyourfingersora#2Phillipsscrewdriver,tightentheknurled
screwontheleftsideofthefanassemblytosecuretheassemblytothe
chassis.
Replace the Front Panel
1. Grasptheleftandrightedgesofthefrontpanelandliftitintoposition
onthefrontofthechassis.
a. AlignthecutoutsforthetouchscreenandtheTAPwiththefrontof
thelibrary.
b. Insertthealignmentpinonthebottomedgeofthefrontpanelinto
thecorrespondingholeinthebottomedgeofthechassis.
Figure 6 Fan assembly installation.
Front edge
PEM nuts
Gasket
material
of chassis
Knurled
screw
Library Front