Spectra T200 - Fan Assembly; Powering off the Library

Replacing the Fan Assembly Replacing a T200, T380, or T680 Fan Assembly
November 2013 Spectra T200, T380, T680, T950 and T-Finity libraries
7
REPLACE THE FAN ASSEMBLY
Replacing a T200, T380, or T680 Fan Assembly
ThissectiondescribeshowtoreplacethefanassemblyinaT200,T380,or
T680library.IfyouneedtoreplaceafanassemblyinaT950orT‐Finity
library,skiptoReplacingaT950orT‐FinityFanAssemblyonpage 14.
Powering off the Library
1. FrontPanel—Poweroffthelibraryfromthefrontpanel(seeLocating
theFansonpage 6).
a. Pressthefrontpanelpowerbuttonforapproximatelysixsecondsor
untilthebutton’sLEDstartsflashing.
b. Waitforthepower‐offsequencetocomplete.Ittakesfromone
minutetofiveminutes(dependingonthelibrary)whilethelibrary
allowsapplicationstoshutdowngracefully.
2. BackPanel—Setthemainpowerswitchesonthelibrarybackpanelto
theoffposition.
Ifyouhaveredundantpowersuppliesinstalled,makesureyouturnoff
bothpowerswitches.
Warning
Risk of electrical shock. Hazardous moving parts. Turn off the power to the library
and disconnect the power cords before accessing the fan.
Figure 1 The back panel AC power switches and connectors.
Main AC power
Power cords
(cord locks installed)
switches
Library Back