The board supplies 5VDC through the receiver module to the external antenna via the coaxial
cable (antenna and cable are sold separately).
The unit can also be operated with an external GNSS receiver (i.e., the receiver is built into the
antenna housing). In this case, the board supplies 12VDC to the receiver/antenna through its
data communications cable.
NOTE – The GNSS receiver and the Spectracom GNSS antenna are compatible
with GLONASS. Utilizing this functionality does not require any additional setup
by the user. In this manual, references to GPS also refer to GLONASS, unless
stated otherwise.
NOTE – The TSync board is compatible with a SAASM receiver for authorized
users. Instructions specific to SAASM operation are provided in a spearate
manual. The SAASM receiver is not compatible with GLONASS.
2.3 Unpacking
Unpack the equipment and inspect it for damage. If any equipment has been damaged in
transit, or you experience any problems during installation and configuration of your Spec
tracom product, please contact your closest Spectracom Customer Service Center (contact
information see "Support" on the next page.)
Caution – Electronic equipment is sensitive to Electrostatic Discharge (ESD).
Observe all ESD precautions and safeguards when handling the unit.
2.4 Product Inventory
Before installing the board, please verify that all material ordered has been received:
All boards are shipped with a break-out cable and a CD containing system drivers, and this
user manual.
Boards equipped with internal GNSS receivers are shipped with an SMA-to-Type-N-RF adapter
cable.
Boards equipped with an external GNSS receiver are shipped with a 100-foot antenna cable
and a mini-DIN to DB-15 adapter cable.
Extension cables for the external GNSS receiver are available in 100-foot lengths. The max
imum total length is 500feet. The connectors on the extension cables are not weatherproof:
2.3 Unpacking
CHAPTER 2 • Instruction Manual XYZ Rev. R
7
To Next Page
Loading...