Spectrum DX8 User Manual

35 

The Monitor screen displays the servo positions for each channel graphically and
numerically. This is useful to verify programming functions, trim settings, mix
directions, etc. The numeric value is directly relative to the travel adjust and mix
values (e.g., 100% travel adjust equals 100% value in the Monitor).

With the transmitter on and the main or telemetry screen displayed, press the
roller. The Function list will display.
Rotate the roller to highlight Monitor then press to access.

 Solution
•Thesystemwillnot
connect
•Yourtransmitterandreceiveraretooclose
together. They should be 8 to 12 feet apart.
•Youarearoundmetalobjects.
•Modelselectedisnotthemodelboundto.
•Yourtransmitterwasaccidentallyputinto
bind mode and is not bound to your receiver
anymore.
•Movetransmitter8to12feetfromreceiver.
•Movetoanareawithlessmetal.
•Checkmodelselectedandensureyouarebound
to that model.
•Rebindyourtransmitterandreceiver.
•Thereceivergoesinto
failsafe mode a short
distance away from the
transmitter
•Checkthereceiverantennatobesureitisnot
cut or damaged.
•Mainandremotereceiverstooclosetogether
•ReplaceorcontactHorizonProductSupport
•Mountmainandremotereceiversatleast2
inches apart and perpendicular to each other.
•Receiverquitsresponding
during operation
•Inadequatebatteryvoltage
•Looseordamagedwiresorconnectosbetween
battery and receiver
•Chargebatteries.Spektrumreceiversrequire
at least 3.5V to operate. An inadequate power
supply can allow voltage to momentarily drop
below 3.5V and cause the receiver to brown out
and reconnect.
•Checkthewiresandconnectionbetweenbattery
and receiver. Repair or replace wires and/or
connectors
•Receiverlosesitsbind
•Transmitterstandortraycouldbedepressing
the bind button
•Bindbuttonpressedbeforetransmitterturned
on
•Ifstandisdepressingbindbutton,removefrom
stand and rebind.
•Rebindyoursystemfollowingbinding
instructions
•Receiverblinkingat
landing
•Abrownouthasoccurred
•Systemturnedonandconnectedthenreceiver
turned off without turning off transmitter
•Check
batteryvoltage
•
Turnofftransmitterwhenreceiveristurnedoff
•RPMwon’tread/display
•Sensortooclosetobackplate;pickinguptipof
crank pin only
•Movesensorsawayfrombackplate
•Temperaturesensorseems
to read low
•Temperaturesensormountedonfrontof
cylinder head being hit by direct prop blast
•Mountsensorbehindcylinderhead.When
installing sensors note engine temperature
with engine properly tuned. Use this as
reference value. If temperature goes above this
significantly, the engine is running too low

EN

Spectrum DX8 Specifications

General

Brand	Spectrum
Model	DX8
Category	Remote Control
Language	English