101501-565 Rev C Page 43 of 58
6.6.5 Request mA Setpoint
Description:
The host requests that the firmware report the current mA setpoint.
Direction:
Host to supply
Syntax:
<STX><15><,><CSUM><ETX>
Response:
If an error is detected, the Power Supply responds with:
<STX>15,!,<ERROR>,<CSUM><ETX>
Please reference the Error Code section for a list of valid error codes.
If the message is accepted, the Power Supply responds with:
<STX>15,<ARG>,<CSUM><ETX>
Where:
<ARG> = 0 - 4095 in ASCII format
Example Response:
MA setpoint is set to full scale.
<STX>15,4095,<CSUM><ETX>
To Next Page
Loading...
